斜坡路基边坡中路堤位移及应力影响参数研究
摘要:采用ANSYS有限元分析软件建立斜坡路基边坡有限元数值模型,分析了不同路堤边坡坡度、地基坡度、路堤高度及路基宽度对路堤位移和应力的影响规律,研究表明:1)斜坡路堤边坡坡度的变化对路堤位移及应力影响较小,建议路堤边坡坡度在1:1.3~1:1.7范围选取;2)随着斜坡地基坡度的增大,路堤位移及剪应力均呈现先增大后减小趋势,建议斜坡地基坡度不超过1:4.5为最佳;3)随着斜坡路堤高度的增大,路堤的位移逐渐增大,最大剪应力先减小后增大,建议实际施工中路堤高度可选取18~22 m;4)斜坡路堤的位移及应力均随着路基宽度的增大而增大,实际工程中建议路基宽度不超过20 m最为理想。
Abstract:The finite element numerical models of slope embankment slope are established by the analysis software ANSYS,and the influence of different embankment slope,foundation slope,embankment height and embankment width are simulated and analyzed with the displacement and stress of embankment.The results show that:1)the slope gradient of slope embankment has little influence on the displacement and stress of embankment,and it is suggested that the slope gradient of embankment should be chosen in the range of 1:1.3~1:1.7;2)with theincrease of slope,the displacement and shear stress of embankment increase first and then decrease.It is suggested that the slope gradient of slope is less than 1:4.5;3)with the height of embankment increasing,the displacement of embankment increased.The maximum shear stress decreases first and then increases.It is suggested that the height of embankment can be chosen of 18~22 m in actual construction;4)the displacement and stress of the slope embankment increase with the increase of the width of the roadbed,and it is suggested that the width of the embankment should not exceed 20 m in practical engineering.
中文标题:
斜坡路基边坡中路堤位移及应力影响参数研究
Study on Influence Parameters of Embankment Displacement and Stress in Slope Subgrade Slope
作者:
魏佩顺
Wei Peishun
作者简介:魏佩顺,男,1965年生,大学本科,高级工程师,主要从事交通工程相关工作。E-mail:sswhgzs01@163.com
通讯地址:
郑州市公路工程公司, 河南郑州 450000
ZhengzhouHighwayEngineeringCompany,Zhengzhou450000,Henan,China
中图分类号:U416.12
doi:10.3969/j.issn.1007-2993.2019.03.009
出版物:岩土工程技术
收稿日期:2018-11-30
网络出版日期:2021-07-06
关键词:斜坡路基边坡,路堤,位移,剪应力
Key words:slope subgrade slope,embankment,displacement,shear stress
文档包含图片数量:图片(0)张
文档包含表格数量:表格(0)个
参考文献:
基金项目:
- 文件大小:
- 993.39 KB
- 下载次数:
- 60
-
高速下载
|
|